Tp Valve Hot Water Heater

Tprs are designed to automatically release water in the event that pressure or temperature in the water tank exceeds safe levels.

Tp valve hot water heater.

The valve is called a t p valve or tpr valve for temperature and pressure relief. If all goes well a tpr valve never gets used except during testing. The temperature pressure relief valve or tpr valve on any heated appliance that contains water such as a heating boiler hot water tank water heater water cylinder must have a drain line or discharge tube properly installed routed and made of proper materials. The last line of defense for pressurized equipment temperature and pressure t p relief valves protect equipment from excess pressure and ultimately catastrophic failure.

Asme ansi and csa aga approved relief valves protect the water heater from excess pressures and temperatures by discharging water. T p valves used on residential water heaters are typically designed and manufactured to relieve pressure at 150 psi and temperature at 210 degrees f. A good solution to this risk is the relief valve. But if the termination of the piping is not readily visible such as if it is located under the house the water will continue to drain until the homeowner gets an amazing electric or gas bill and goes searching for the reason.

When the water temperature is in the range of 120 to 140 degrees fahrenheit a metal tank that holds hot water will expand. If the water inside the unit gets too hot usually above 210 degrees or pressure builds up too high above 150 psi the water heater can become damaged or even explore. A high quality t p valve on water heater will do it for you automatically. Tighten it with a wrench but don t over tighten.

Then screw the new valve into the water heater turning it clockwise. The temperature must be kept stable or controlled by opening the valve automatically. 6 wind teflon pipe thread tape on the threads of the new t p valve winding counterclockwise. Temperature pressure relief or tpr valves are safety devices installed on water heating appliances such as boilers and domestic water supply heaters.

Every water heater whether gas or electric needs a temperature and pressure relief valve because without one it could begin to leak or even explode. The purpose of this drain line is to discharge potentially hot scalding water to a safe location so that a bystander is not scalded. Unscrew the old t p valve from the water heater turning it counterclockwise with a large wrench. The t and p valve which is located on the.